Select Cable
Select CableADJUSTMENT
1) Set the vehicle on a lift.
2) Shift the select lever to "N" range.
3) Lift up the vehicle.
4) Remove the rear exhaust pipe.
5) Remove the heat shield cover.
6) Loosen the adjusting nuts on both sides.
7) Turn adjusting nut B until it lightly touches the connector.
8) Set a spanner wrench to adjusting nut B so that it does not rotate, and then tighten the adjusting nut A.
Tightening torque:
7.5 Nm (0.76 kgf-m, 5.5 ft-lb)
9) After the completion of adjustment, confirm that the select lever operates normally at all ranges.
10) Install in the reverse order of removal.