Neutral Switch & Backup Switch
Switches and HarnessREMOVAL
BACK-UP LIGHT AND NEUTRAL POSITION SWITCH
1) Disconnect the ground cable from battery.
2) Remove the intercooler.
3) Disconnect the connector back-up light switch & neutral position switch.
4) Lift up the vehicle.
5) Remove the back-up light switch & neutral position switch with the harness.
INSTALLATION
BACK-UP LIGHT AND NEUTRAL POSITION SWITCH
1) Install the back-up light switch & neutral position switch with the harness.
Tightening torque:
32.3 Nm (3.3 kgf-m, 23.8 ft-lb)
2) Connect the connectors of back-up light switch & neutral position switch.
3) Install the intercooler.
4) Connect the battery ground terminal.
INSPECTION
BACK-UP LIGHT SWITCH
Check the back-up light switch.
NEUTRAL POSITION SWITCH
1) Turn the ignition switch to OFF.
2) Disconnect the connector of neutral position switch.
3) Measure the resistance between neutral position switch terminals.
4) Replace faulty parts.