Throttle Body: Service and Repair

Throttle Body

REMOVAL

1. Disconnect the ground cable from battery.






2. Lift up the vehicle.
3. Remove the under cover.
4. Drain approximately 3.0 l (3.2 US qt, 2.6 Imp qt) of coolant.
5. Remove the intercooler.
6. Disconnect the connector (A) from the throttle position sensor, and the connector (B) from the manifold pressure sensor.






7. Disconnect the engine coolant hose from throttle body.






8. Remove the throttle body from the intake manifold.






INSTALLATION

Install in the reverse order of removal.

NOTE: Use a new gasket.

Tightening torque: 8 N.m (0.8 kgf.m, 5.9 ft.lb)