Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor

REMOVAL

1. INTAKE SIDE

- Camshaft position sensor RH
1. Disconnect the ground cable from the battery.






2. Disconnect the connector (A) from the camshaft position sensor RH, and remove the camshaft position sensor RH from the rear side of the cylinder head.






- Camshaft position sensor LH
1. Disconnect the ground cable from battery.






2. Remove the intake manifold.
3. Remove the camshaft position sensor LH.






2. EXHAUST SIDE

1. Disconnect the ground cable from the battery.






2. Lift up the vehicle
3. Remove the under cover.
4. Remove the engine harness cover. (Right side only)






5. Disconnect connector (A) from the camshaft position sensor, and remove the camshaft position sensor from under the cylinder head.
- RH side






- LH side






INSTALLATION

1. INTAKE SIDE
Install in the reverse order of removal.

Tightening torque: 6.4 N.m (0.7 kgf.m, 4.7 ft.lb)

2. EXHAUST SIDE
Install in the reverse order of removal.

Tightening torque: 6.4 N.m (0.7 kgf.m, 4.7 ft.lb)

- RH side






- LH side






Tightening torque: 5 N.m (0.5 kgf.m, 3.7 ft.lb)