Overhaul

Steering Column

DISASSEMBLY

Remove the three screws securing the upper steering column covers, and the two screws securing the combination switch, and then remove related parts.

ASSEMBLY

Insert the combination switch to the upper column shaft, and install the upper column cover. Then route the ignition key harness and combination switch harness between the column cover mounting bosses.

CAUTION:
Do not overtorque the screw.

Tightening torque:
1.2 Nm (0.12 kgf-m, 0.9 ft-lb)

INSPECTION

BASIC INSPECTION

Measure the overall length of steering column. If not within specification, replace it.

Standard: Overall length L
Tilt and telescopic column (measure while minimized)
818.6[+1.5/-1.5] mm (32.23[+0.059/-0.059] in)





INSPECTION OF AIRBAG SYSTEM

Refer to "Airbag Systems" for airbag inspection procedure.