Collision Avoidance and Parking Assist Systems: Testing and Inspection

Rearview Camera System

INSPECTION
1. Park the vehicle at the level place where there are enough area at the rear of the vehicle.
2. Attache the tape as the target point for standard at the floor rearward of the vehicle as shown in the figure below.

NOTE: Standard tape width is about 30 - 50 mm (1.18 - 1.97 in) and brilliant color shall be used.






3. Confirm the following before checking the corresponding items.
- If the display is blank.
Rearview camera image is not displayed. (Navigation screen is displayed normally.)
1. Check the condition of back sensor connection. Testing and Inspection
2. Check the condition of rearview camera connection. Testing and Inspection

- If the marker is not displayed.
1. Check the UART communication. Testing and Inspection

- If the marker position is not aligned.
1. Adjust the marker position according to the MARKER ADJUSTMENT MODE.