Headlamp: Service and Repair
Headlight AssemblyREMOVAL
CAUTION: Do not perform work with wet hands.
1. Disconnect the ground cable from battery.
2. Remove the clips and remove the air intake duct. (When removing the headlight RH).
3. Remove the front bumper face assembly.
4. Remove the fender cover assembly UPR.
1. Remove the clip.
2. Release the claws of the fender cover assembly UPR by pulling it forward and remove the fender cover.
5. Remove the headlight assembly.
1. Remove the bolts and clips, and pull out the headlight assembly to the front of the vehicle.
2. Disconnect the connector and remove the headlight assembly.
- Headlight connector RH
- Headlight connector LH
INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
Headlight ASSY: 7.5 N.m (0.76 kgf.m, 5.5 ft.lb)