Tail/Stop Light Bulb
Tail/Stop Light BulbREMOVAL
1. SEDAN MODEL
- Rear combination light side
1. Disconnect the ground cable from battery.
2. Release the lock and remove the bulb inspection cover of trunk room trim.
3. Remove the bulb socket and tail light/stop light bulb.
- Rear finisher light side
1. Disconnect the ground cable from battery.
2. Remove the trunk lid trim.
3. Remove the bulb socket and tail light bulb.
2. OUTBACK MODEL
- Rear combination light side
1. Disconnect the ground cable from battery.
2. Remove the clips and detach the rear combination light covers.
3. Remove the rear combination light assembly.
CAUTION: Be careful not to damage the clips.
1. Release the bolts and clips, then pull out the rear combination light assembly to the vehicle rear.
2. Disconnect the connector and remove the rear combination light assembly.
4. Remove the bulb sockets and bulbs.
- Rear finisher light side
1. Release the claws and remove the bulb inspection cover of rear gate trim
2. Remove the bulb socket and tail light bulb.
INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
Rear combination light ASSY: 7.5 N.m (0.76 kgf.m, 5.5 ft.lb)