AT Oil Temp Warning Light Display
AT OIL TEMP Warning Light DisplayOPERATION
When any on-board diagnostics item is malfunctioning, or the learning has not yet completed, AT OIL TEMP light blinks. Blinking continues from the engine start to the ignition switch OFF. The malfunctioning part or unit can be determined by a DTC. Problems which occurred previously can also be identified through the memory function. If the AT OIL TEMP light does not blink although a problem is occurring, the problem can be determined by checking the performance characteristics of each sensor using the Subaru Select Monitor. If the learning has not yet completed, "AT learning not completed" is displayed when the Subaru Select Monitor is connected while AT OIL TEMP light is blinking. The AT OIL TEMP light blinking will go off, when the learning is performed. Indicator light signal patterns are as shown in the figure.
When the AT OIL TEMP light does not operate normally, check the AT OIL TEMP light circuit. AT Oil Temp Warning Light Display
INSPECTION
DIAGNOSIS:
^ AT OIL TEMP light circuit is open or shorted.
^ Combination meter malfunction
TROUBLE SYMPTOM:
^ When the ignition switch is turned to ON, the AT OIL TEMP light does not illuminate.
^ AT OIL TEMP light remains lit after engine start.
WIRING DIAGRAM:
