Operation CHARM: Car repair manuals for everyone.

Battery: Service and Repair

Battery

REMOVAL
1. After disconnecting the battery ground terminal, remove the terminal cover, then disconnect the positive terminal.
2. Remove the battery cable holder from the battery rod.
3. Remove flange nut from the battery rod and remove battery holder.






4. Remove the battery.


INSTALLATION
Install in the reverse order of removal.

Tightening torque: 3.5 N.m (0.4 kgf.m, 2.6 ft.lb)

NOTE:
- Clean the battery cable terminals and apply grease to retard the formation of corrosion.
- Connect the battery positive (+) terminal, and then connect the negative (-) terminal.
- After the battery is installed, initial diagnosis of the electronic throttle control is performed. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.