Clutch Switch: Service and Repair
Clutch SwitchREMOVAL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover.
3) Disconnect the connector from clutch switch.
4) Remove the clutch switches.
INSTALLATION
CLUTCH SWITCH
1) Move the clevis pin of push rod to left and right, retain it at the position where it moves smoothly, and measure the clutch pedal stroke.
Clutch pedal full stroke A:
130 - 135 mm (5.12 - 5.31 in) (non-turbo model)
135 - 140 mm (5.31 - 5.51 in) (turbo model)
Tightening torque:
T: 8 Nm (0.8 kgf-m, 5.9 ft-lb)
2) If the clutch pedal stroke is out of specification, adjust the stroke.
3) Connect the connector to the clutch switch.
CLUTCH START SWITCH
1) Fully depress the clutch pedal and hold it.
2) Install so that gap (A) of the clutch pedal plate and clutch start switch is 2.9 mm (0.11 in), and tighten the lock nut.
Tightening torque:
8 Nm (0.8 kgf-m, 5.9 ft-lb)
3) Connect the connector to the clutch start switch.
4) Make sure that engine does not start with clutch pedal not depressed.
5) Make sure that engine starts with clutch pedal fully depressed.
INSPECTION
CLUTCH START SWITCH
1) Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again.
^ Make sure that engine does not start with clutch pedal not depressed.
^ Make sure that engine starts with clutch pedal fully depressed.
2) When the clutch start switch does not operate normally even if it is adjusted, check the clutch start switch for continuity.
(1) Remove the clutch start switch.
(2) Measure the resistance between terminal 1 and 2 of the switch. If the resistance is not at the standard value, replace the switch.
(3) Check that the switch is turned on and off in Dimension L.
Dimension L:
4 - 5.5 mm (0.16 - 0.22 in)
CLUTCH SWITCH
1) Check the clutch switch for continuity.
(1) Disconnect the connector of clutch switch.
(2) Measure the resistance between terminal 1 and 2 of the switch. If the resistance is not within the specification, check the clutch stroke and installation condition, and check the clutch switch again.
2) When the clutch switch does not operate normally even if the clutch stroke and installation condition are normal, check the clutch switch for continuity.
(1) Remove the clutch switches.
(2) Measure the resistance between terminal 1 and 2 of the switch. If the resistance is not at the standard value, replace the switch.
(3) Check that the switch is turned on and off in Dimension L.
Dimension L:
5 - 6.5 mm (0.2 - 0.26 in)
ADJUSTMENT
1) Loosen the lock nut of the clutch start switch.
2) Fully depress the clutch pedal and hold it.
3) Adjust the gap (A) of the clutch pedal plate and the clutch start switch to be 2.9 mm (0.11 in).
4) Tighten the lock nut.
Tightening torque:
8 Nm (0.8 kgf-m, 5.9 ft-lb)