Collision Avoidance and Parking Assist Systems: Adjustments

Rearview Camera System

ADJUSTMENT

1. MARKER ADJUSTMENT MODE
1. Prepare the target point. Testing and Inspection
2. Display the audio OFF screen by turning the ignition switch to ON, then touch the screen in the order of (1) - (6).






3. When the Dealer Diag menu screen is displayed, touch the "Rear Camera Setup" from the items.






CAUTION: Do not select the item other than "RearCamera Setup". The navigation system can not operate normally.

4. Shift the select lever to the "R" position to display the image of the rearview camera.
5. Touch the adjustment keys on the display screen to adjust the marker line.
- Sedan model






- OUTBACK model






1. Confirm that the target point position in the display screen is identified.
2. Adjust by touching the adjustment keys so that the cross line (E) and target point join together.

NOTE:
- Hide OSD key: Touching the Hide OSD key hides the operation keys. When the operation keys are not displayed, touching the display screen displays the operation keys again.
- Menu key: Touching this key shifts to the Dealer Diag Menu screen.
- Default key: Touching this key resets the adjustment values to the default condition.

6. Turn the ignition switch to OFF and wait for 60 seconds or more before turning the ignition switch to ON again.

CAUTION: If the ignition switch is turned to OFF, be sure to wait for 60 seconds or more before turning the ignition switch to ON again.
If turning the ignition switch to ON again or disconnecting the ground cable from battery within 60 seconds after turning the ignition switch to OFF, the navigation unit data updating can not be performed correctly.

7. Shift the select lever to the "R" position to display the image of the rearview camera.
8. Confirm that the marker line position is correctly adjusted before turning the ignition switch to OFF, then finish the procedures.