Horn Switch: Service and Repair

Horn Switch

REMOVAL

CAUTION: Before handling the airbag module, refer to "CAUTION" of "General Description" in the "AIRBAG SYSTEM" section.

NOTE: Horn switch is a unit with the driver's airbag module.

1. Position the front wheels straight ahead. (After moving a vehicle 5 m (16 ft) or more with front wheels positioned straight ahead, make sure that the vehicle moves straight ahead.)
2. Turn the ignition switch to OFF.
3. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
4. Remove the driver's airbag module assembly.

Preparation tool: TORX(R) T30

1. Loosen the TORX(R) bolts located on the sides of the steering wheel.






2. Disconnect the horn harness and airbag connector and remove the airbag module assembly.






INSTALLATION

CAUTION:
- Before handling the airbag module, refer to "CAUTION" of "General Description" in the "AIRBAG SYSTEM" section.
- Do not allow harness and connectors to interfere or get tangled up with other parts.

1. Install the driver's airbag module.
2. Install each part in the reverse order of removal.

Tightening torque:
Driver's airbag module: 10 N.m (1.02 kgf.m, 7.4 ft.lb)