Fluid Pressure Sensor/Switch: Service and Repair
Secondary Pressure SensorREMOVAL
CAUTION:
^ Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.
^ When removing secondary pressure sensor, CVTF may let out. If CVTF has leaked, adjust the CVTF level after installing the secondary pressure sensor.
1) Remove the air intake boot assembly.
2) Remove the secondary pressure sensor connector.
3) Remove the secondary pressure sensor.
NOTE:
Use Ko-ken 3/8 12-point 27 mm (manufacturer product No. 3305M-27) deep socket.
INSTALLATION
CAUTION:
^ Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.
^ After installing the secondary pressure sensor, adjust the CVTF level.
Install in the reverse order of removal.
NOTE:
Use new O-rings.
Tightening torque:
39 Nm (4.0 kgf-m, 28.8 ft-lb)