Assembly

Front Arm

ASSEMBLY

FRONT BUSHING

1) Before assembly, inspect the following items and replace any faulty part with a new one.
^ Check the front arm for damage or cracks, and replace if defective.
^ Visually check the bushing for abnormal cracks, fatigue or damage.
^ Visually check the dust cover on the ball joint for damage.
2) Assemble each part in the reverse order of disassembly.

REAR BUSHING

1) Before installation, inspect the following items and replace any faulty part with a new one.
^ Check the front arm for damage or cracks, and replace if defective.
^ Visually check the bushing for abnormal cracks, fatigue or damage.
^ Visually check the dust cover on the ball joint for damage.
2) Align the center of recess portion with the alignment mark on the front arm, with the protrusion (A) of recess portion facing the front side of vehicle.





3) Using the ST and a press, install the rear bushing.

CAUTION:
Align the upper face of front arm and the end of bushing during installation.





PREPARATION TOOL:
ST1: REMOVER (20299AG000)
ST2: BASE (20299AG010)