Power Seat System

Power Seat System

REMOVAL

CAUTION: When removing the front seat, Disconnect the ground cable from battery before disconnecting the side airbag module harness connector, and wait for 60 seconds before starting the operation.

1. POWER SEAT SWITCH

1. Remove the seat from vehicle.
2. Remove the seat side cover OUT.
1. Release the claw in the rear section of the seat side cover.
2. Release the claw in the upper section of the seat side cover.
3. Remove the clip and release the claw in the front section of the seat side cover
4. Disconnect the power seat switch and lumber switch connectors and remove the seat side cover OUT.







3. Remove the screws to remove the power seat switch assembly.







2. LUMBAR SWITCH

1. Remove the seat from vehicle.
2. Remove the seat side cover OUT.
1. Release the claw in the rear section of the seat side cover.
2. Release the claw in the upper section of the seat side cover.
3. Remove the clip and release the claw in the front section of the seat side cover
4. Disconnect the power seat switch and lumber switch connectors and remove the seat side cover OUT.







3. Disconnect the connector and remove the lumbar switch assembly.







INSTALLATION

Install each part in the reverse order of removal.