Manifold Pressure/Vacuum Sensor: Service and Repair
Manifold Absolute Pressure SensorREMOVAL
1. Remove the collector cover.
NOTE: Follow these procedures for removal of the collector cover.
1. Lift up the rear side holding two positions (A).
2. Lift up the front side holding two positions (B) while moving it in the forward direction of the vehicle.
2. Disconnect the ground cable from battery.
3. Disconnect the manifold pressure sensor connector.
4. Remove the manifold pressure sensor and the filter and hose from intake manifold.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 6.4 N.m (0.7 kgf.m, 4.7 ft.lb)