Crankshaft Position Sensor: Service and Repair
Crankshaft Position SensorREMOVAL
1. Remove the collector cover.
NOTE: Follow the steps below when removing the collector cover.
1. Pull up the two points at the rear (A).
2. Pull up the two points at the front (B) while moving them forward.
2. Disconnect the ground cable from battery.
3. Remove the air intake boot assembly.
4. Remove the throttle body from the intake manifold.
NOTE: Do not disconnect the inlet and outlet hoses of engine coolant.
5. Remove the service hole plug.
6. Remove the crankshaft position sensor.
7. Disconnect the connector from crankshaft position sensor.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 6.4 N.m (0.7 kgf.m, 4.7 ft.lb)
