Installation
Select LeverINSTALLATION
1) Set the select lever to vehicle body.
2) Tighten the four mounting bolts to attach the select lever to the vehicle body.
Tightening torque:
18 Nm (1.8 kgf-m, 13.3 ft-lb)
3) Connect the harness connector.
4) Install the harness clip to the select lever.
5) Shift the select lever to "N" range.
6) Install the console box and the console front cover assembly.
7) Accessing from the button side of the grip, attach the clamp grip pin.
8) Install the cover grip AT securely.
NOTE:
After installation, check that the cover grip AT cannot be detached.
9) Insert the grip assembly to the select lever and press it down until a click is heard.
10) After installation of grip, check the following points.
^ The grip will not come off.
^ The button on the grip operates normally.
11) Lift up the vehicle.
12) Shift the range select lever to "N" range.
13) Secure the cable to the bracket.
14) Adjust the select cable position.
15) After adjustment, confirm that the select lever operates properly at all range positions using the shift lock release button.
16) Install the heat shield cover.
Tightening torque:
18 Nm (1.8 kgf-m, 13.3 ft-lb)
17) Install the rear exhaust pipe.
^ 2.5 L non-turbo model
18) Inspect the following items. If a malfunction is found in the inspection, adjust the select cable or inhibitor switch (CVT model).
(1) The shift lock operates normally. Initial Inspection and Diagnostic Overview
(2) Engine starts when the select lever is in "P" or "N" range, but not in other ranges.
(3) Back-up light illuminates when the select lever is in the "R" range, but not in other ranges.
(4) Select lever and indicator positions are matched.