Subaru Select Monitor

Subaru Select Monitor

OPERATION

1. READ DIAGNOSTIC TROUBLE CODE (DTC)
When malfunction of airbag system occurs, the DTC stored in airbag control module will be read out.

1. Prepare the Subaru Select Monitor kit.
2. Connect the diagnosis cable to Subaru Select Monitor.
3. Connect the Subaru Select Monitor to data link connector.
1. Data link connector is located in the lower portion of instrument panel (on the driver's side).






2. Connect the diagnosis cable to data link connector.


CAUTION: Do not connect the scan tools other than the Subaru Select Monitor.

4. Turn the ignition switch to ON and run the Subaru Select Monitor.
5. On {{Main Menu}} display, select {Each System Check}.
6. On {{System Selection Menu}} display, select {Airbag System}.
7. After {Airbag System} is displayed, select [OK].
8. Select the {Diagnostic Code(s) Display} in {{Airbag System}}.

NOTE:
- For details concerning the operation procedure, refer to "PC application help for Subaru Select Monitor".
- For details concerning DTCs, refer to List of Diagnostic Trouble Code (DTC).Airbag System (Diagnostics)

2. CLEAR MEMORY MODE
Clear the DTC stored in the airbag control module after repairing the airbag system. (After the breakdown is recovered, the breakdown code for completed recoveries are read out when the next breakdown occurs if the memory clear work is not performed.)

1. On {{Main Menu}} display, select {Each System Check}.
2. On {{System Selection Menu}} display, select {Airbag System}.
3. Select the {Clearing Memory} in {{Airbag System}}.
4. When the "Clear Memory?" is shown on the screen, select the [OK] button.
5. When "Done" is displayed, end the Subaru Select Monitor.

NOTE: For details concerning the operation procedure, refer to "PC application help for Subaru Select Monitor".

3. DISPLAY OF STATUS INFORMATION
Check the operating condition of each sensor in the event of malfunction in the seat belt buckle switch, or when the seat belt buckle switch has been replaced.

1. On {{Main Menu}} display, select {Each System Check}.
2. On {{System Selection Menu}} display, select {Airbag System}.
3. Select the {Status Data} in {{Airbag System}}.
The following table is for support data.





NOTE: For details concerning the operation procedure, refer to "PC application help for Subaru Select Monitor".

INSPECTION

COMMUNICATION FOR INITIALIZING IMPOSSIBLE

DETECTING CONDITION:
Defective harness connector

TROUBLE SYMPTOM:
Communication is impossible between the airbag control module and the Subaru Select Monitor.

WIRING DIAGRAM: