Front Sub Sensor

Front Sub Sensor

REMOVAL

1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Remove the front bumper face.






6. Disconnect the connector from front sub sensor.

INSTALLATION

CAUTION:
- Do not reuse the bolt and nut.
Always replace with the specified new bolts and nuts.

- When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely.
- After the installation of headlight assembly, be sure to perform headlight beam adjustment.

Install each part in the reverse order of removal.

Tightening torque: 13 N.m (1.33 kgf.m, 9.6 ft.lb)