Rear ABS Sensor
ABS WHEEL SPEED SENSORRear ABS Wheel Speed Sensor
REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the connector from the rear ABS wheel speed sensor.
3) Remove the sensor harness clamp of the rear sub frame.
4) Remove the sensor harness bracket from the upper arm.
5) Remove the rear ABS wheel speed sensor from the rear axle.
CAUTION:
^ Be careful not to damage the sensor.
^ Do not apply excessive force to the sensor harness.
INSTALLATION
CAUTION:
Be careful not to damage the sensor.
Install each part in the reverse order of removal.
Tightening torque:
Sensor:
7.5 Nm (0.76 kgf-m, 5.5 ft-lb)
Bracket:
7.5 Nm (0.76 kgf-m, 5.5 ft-lb)
NOTE:
Check the identification (mark) on the harness to make sure there is no warpage. (RH: P5 (White), LH: P6 (Yellow))
INSPECTION
ABS WHEEL SPEED SENSOR
Refer to "Front ABS Wheel Speed Sensor".