Removal and Replacement
StarterREMOVAL
1. Disconnect the ground cable from battery.
2. Remove the air intake chamber.
3. Remove the air intake chamber stay LH.
- MT model
- AT model
4. Disconnect the connector (B) and terminal (A) from starter.
5. Remove the starter from transmission.
NOTE: For the MT model, a bolt is used in place (A).
INSTALLATION
Install in the reverse order of removal.
NOTE: For the MT model, a bolt is used in place (A).
Tightening torque: 50 N.m (5.1 kgf.m, 36.9 ft.lb)
