Removal and Replacement

Select Lever

REMOVAL

1) Set the vehicle on a lift.
2) Shift the select lever to "N" range.
3) Disconnect the ground cable from battery.
4) Lift up the vehicle.
5) Remove the rear exhaust pipe.
6) Remove the heat shield cover.





7) Remove the cable from arm assembly.





8) Raise the claw of clamp and remove the cable.





9) Lower the vehicle.
10) Remove the grip.
11) Remove the parking brake lever boot.
12) Remove the console front panel.





13) Remove the console cover and console box.
14) Remove the indicator assembly.





15) Remove the harness clips from the bracket.
16) Remove the blind.





17) Disconnect the connectors, and then remove the four bolts to take out the select lever assembly from vehicle body.





INSTALLATION

1) Set the select lever to the vehicle body.
2) Tighten the four bolts to install the select lever assembly to vehicle body, and connect the connector.
(1) Temporarily tighten the bolt A.
(2) Tighten the bolt B.
(3) Tighten the bolt A.
(4) Tighten the bolts C and D.

Tightening torque:
18 Nm (1.8 kgf-m, 13.3 ft-lb)





3) Install the harness clips to the bracket.
4) Install the console cover and console box.
5) Shift the select lever to "N" range.
6) Install the blind.

CAUTION:
The blind should be installed so that it is securely caught by tabs of the plate guide COMPL.





7) Install the indicator assembly.
8) Install the console front panel.
9) Install the parking brake lever boot.
10) Install the grip.
11) Lift up the vehicle.
12) Shift the range select lever to "N" range.
13) Secure the cable to the bracket.
14) Adjust the select cable position.
15) After the completion of adjustment, confirm that the select lever operates properly at all range positions.
16) Install the heat shield cover.
17) Install the rear exhaust pipe.
18) Lower the vehicle.
19) Connect the battery ground terminal.
20) Inspect the following items. When a malfunction is found in the inspection, adjust the select cable and inhibitor switch.
(1) Engine starts when the select lever is in "P" and "N" range, but not in other ranges.
(2) Back-up light illuminates when the select lever is in the "R" range, but not in other ranges.
(3) Select lever and indicator positions are matched.