Operation CHARM: Car repair manuals for everyone.

Symptom Related Diagnostic Procedures

SECURITY SYSTEM

INSPECTION

BASIC DIAGNOSTIC PROCEDURE









NOTE: If the horn sounds when the security is turned on (monitor condition) using the keyless transmitter, check the function setting of the body integrated unit. As a cause, it is possible that the impact sensor present (ON) / not present (OFF) setting is set to ON in the customization function though there is no impact sensor.

CHECK SECURITY SYSTEM CONDITION MEMORY
1. Pull out the key from the ignition switch, or turn the ignition to OFF.
2. Close all the doors and the rear gate.
3. Open the front hood.
4. Press the LOCK button of the keyless transmitter.

NOTE:
- Wait until the security indicator light blinks twice within 0.5 seconds at 2 second intervals.
- If the 30 second monitoring lag has been set, wait 30 seconds.

5. Disconnect the ground cable from the battery.
6. Connect the ground cable to the battery.
7. Check that the security indicator light blinks twice within 0.5 seconds at 2 second intervals. When it does not blink, replace the body integrated unit.


SECURITY SYSTEM ON/OFF SETTING
1. Close all doors and rear gate, and sit in the driver's seat. Press the UNLOCK button of the keyless transmitter.
2. Turn the ignition switch to ON.
3. Push the centralized door lock switch down and open the driver's side door at the same time, and hold in this condition for 10 seconds. (Keep the central door unlock switch pressed down.)
4. If the security system is ON, it will turn OFF. If OFF, it will turn ON.






CHECK DOOR SWITCH

For operation procedure, refer to "CHECK DOOR SWITCH" of "Keyless Entry System". Testing and Inspection

CHECK SECURITY INDICATOR LIGHT CIRCUIT

For operation procedures, refer to "CHECK SECURITY INDICATOR LIGHT CIRCUIT" of "IMMOBILIZER (DIAGNOSTICS)". Component Tests and General Diagnostics


CHECK HORN





CHECK HAZARD LIGHT OPERATION

For operation procedure, refer to "CHECK HAZARD LIGHT OPERATION" of "Keyless Entry System". Testing and Inspection


CHECK IGNITION SWITCH CIRCUIT