Trunk / Liftgate Interior Trim Panel: Service and Repair

Rear Gate Trim







REMOVAL

1. Remove the high-mounted stop light.
2. Remove the clips, and remove the rear gate upper trim.







3. Using a plastic clip remover, disengage the trim tabs and remove the rear gate pillar trim.







4. Remove the hand grip and clip of rear gate.

CAUTION: Be careful not to scratch the trim.







1. Open the cover by using a plastic remover, etc.
2. Remove the screws and detach the hand grip.

NOTE: If the screw cover cannot be opened, perform the procedures indicated in the figure.







5. Remove the clips and rear gate lower trim.







INSTALLATION

Install each part in the reverse order of removal.