Combination Base Switch Assembly
Combination Base Switch AssemblyREMOVAL
1. Remove the driver's airbag module.
2. Remove the steering wheel.
3. Remove the screws and remove the steering column cover lower.
4. Remove the harness cover lock.
5. Remove the screws and detach the knee protector.
6. Remove the screws and remove the steering column upper cover.
7. Remove the screws, and then remove the roll connector.
8. Remove the screws, disconnect the harness connector and remove the combination base switch assembly.
9. Remove the combination switch from the combination base switch assembly.
- Combination Switch (light).
- Combination Switch (wiper).
INSTALLATION
1. Before installing steering wheel, be sure to adjust the direction of roll connector with steering.
2. Install each part in the reverse order of removal.