Output Shaft Oil Seal
REPLACEMENT1) Lift up the vehicle.
2) Clean the transmission exterior.
3) Using the TORX(R) bit T70, remove the drain plug, and drain the transmission gear oil completely.
4) Tighten the drain plug using TORX(R) bit T70.
NOTE:
Use a new gasket.
Tightening torque:
44 Nm (4.5 kgf-m, 32.5 ft-lb) (Aluminum gasket silver)
70 Nm (7.1 kgf-m, 51.6 ft-lb) (Copper gasket brown)
70 Nm (7.1 kgf-m, 51.6 ft-lb) (Metal gasket black)
5) Remove the rear exhaust pipe and muffler.
6) Remove the heat shield cover.
7) Remove the propeller shaft.
8) Using the ST, remove the oil seal.
ST 398527700 PULLER ASSY
9) Using the ST, install the oil seal.
NOTE:
- When grease is not applied to the oil seal lips, apply the transmission gear oil to the oil seal lips.
- Use a new oil seal.
ST 498057300 INSTALLER
10) Install the propeller shaft.
11) Install the heat shield cover.
12) Install the rear exhaust pipe and muffler.
13) Lower the vehicle.
14) Pour in transmission gear oil and check the oil level.