Trunk / Liftgate Latch: Service and Repair

Trunk Lid Latch and Actuator Assembly

REMOVAL

1. Disconnect the ground cable from battery.
2. Remove the lock assembly - trunk lid.
1. Disconnect the connector.
2. Release the claws, and open the lock cover.
3. Remove the bolts, and disconnect the release cable, and then remove the lock assembly - trunk lid.






NOTE: When disconnecting the release cable, refer to "TRUNK LID OPENER" of "Remote Openers".


INSTALLATION

1. Before installation, check the following items.
- Is the cable deformed?
- Grease is applied sufficiently to cable joints.
If grease is insufficient, add it as necessary before assembling the cable.

2. Install each part in the reverse order of removal.

Tightening torque:
T1: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
T2: 25 N.m (2.55 kgf-m, 18.4 ft-lb)