Upper Inner Trim

Upper Inner Trim

REMOVAL

1. Remove the trim panel - front pillar UPR.
1. Pull the upper part of the trim panel - front pillar UPR towards the center of the vehicle.
2. Insert long-nose pliers into the top part of the trim, grip the clip with the pliers and twist 90� in that position.

CAUTION: Be careful not to damage the pillar trim surface and curtain airbag module when inserting the pliers.

3. Holding the clip twisted as in the previous step, remove the trim panel - front pillar UPR from the clip.
4. Remove the clips, and remove the trim panel - front pillar UPR.







2. Release the claws, and then remove the cover side sill - front INN.

CAUTION: Do not pull with excessive force. Doing so may damage the claws of the cover side sill - front INN.







3. Remove the rear seat cushion assembly.
1. Push the corners of the rear seat cushion from above.
2. While pushing the corners of the rear seat cushion from above, pull the knob of the hook - seat cushion rear towards yourself.
3. While pulling the knob towards yourself, disconnect the hooks by lifting up the rear seat cushion.

NOTE: Pull the left side of the knob to disconnect the LH side hook, and pull the right side of the knob to disconnect the RH side hook.







4. Remove the hook (A) by pushing it back while lifting the front side of the rear seat cushion, and remove the rear seat cushion.







4. Release the clips and claws, and then remove the cover side sill - rear INN.

CAUTION: Do not pull with excessive force. Doing so may damage the claws of the cover side sill - rear INN.







5. Remove the trim panel - center pillar LWR.
1. Release the clip by pulling the trim panel - center pillar LWR toward you.
2. Expand the claws of the trim panel - center pillar LWR outward, and remove it from the trim panel -center pillar UPR.

CAUTION: Do not expand the trim panel - center pillar LWR excessively. Doing so may damage the trim.







NOTE: First release the claw located to the front of the vehicle.

6. Remove the trim panel - center pillar UPR.
1. Remove the cover through (a), and remove the seat belt anchor bolt.
2. Remove the bolt on the lower side of the trim panel - center pillar UPR.
3. Remove the clip, and while lowering the entire trim, remove the trim panel - center pillar UPR.







INSTALLATION

CAUTION:
- Do not reuse the clips in the upper section of the trim panel - front pillar UPR. Always replace with a new part.
The holding force of the clips is reduced once they are removed from the pillar trim. Reuse might result in the trim panel - front pillar UPR falling off.
- Do not reuse the clips in the upper section of the trim panel - center pillar UPR. Always replace with a new part.
The holding force reduces once the pillar trim is removed, and the trim panel - center pillar UPR may come off.
- Before installing the trim panel - front pillar UPR, check the condition of protective non-woven fabric (white) of the curtain airbag. If it is damaged (airbag module cloth is exposed), replace the curtain airbag module assembly with a new part.

1. Remove the remaining clips from the vehicle body.
2. Prepare new clips and attach the clips to the trim panel - front pillar UPR.
3. Install the trim panel - front pillar UPR.







4. Install each part in the reverse order of removal.

Tightening torque
Front seat belt: [Ref. to FRONT SEAT BELT, COMPONENT, General Description.]