Keyless Entry Receiver: Service and Repair

Keyless Entry Control Module

REMOVAL

1. 4 DOOR MODEL
1. Disconnect the ground cable from battery.
2. Remove the trim panel assembly - rear shelf.
3. Remove the keyless entry control module.
1. Disconnect the connector.
2. Remove the bolt and then remove the keyless entry control module.






2. 5 DOOR MODEL
1. Disconnect the ground cable from battery.
2. Remove the trim panel - rear apron LH.
3. Remove the keyless entry control module.
1. Disconnect the connector.
2. Remove the bolt and then remove the keyless entry control module.






INSTALLATION

Install each part in the reverse order of removal.

Tightening torque:
Keyless entry control module: 13 N.m (1.33 kgf-m, 9.6 ft-lb)