Rear Seat

DISASSEMBLY

1. Remove the rear seat.
2. Remove the pillow assembly - rear backrest.
3. Remove the armrest assembly - rear center. (model with armrest assembly - rear center)
1. Remove the cover - armrest by pulling it in the direction of the arrow (black).
2. Remove the screws and remove the armrest assembly - rear center.







NOTE: The armrest assembly - rear center cannot be detached unless pin positions on the RH side of the backrest assembly and on the center side of the armrest assembly - rear are aligned.

4. Remove the knob - backrest. (Screw-in type)







5. Remove the tether anchor cover.







6. Remove the clips on the backside of the cover COMPL - rear backrest LH.







7. Detach the plastic fastener at the bottom of backrest assembly LH and turn over the cover COMPL - rear backrest LH.







8. Remove the plastic hooks on the back side of the backrest assembly LH.







9. Remove the lock assembly - rear backrest rear LH.







10. Detach the bushing - headrest and the bushing - lock assembly, and remove the frame assembly - rear backrest LH from the pad assembly - main LH.







11. Remove the hog rings (A), then remove the cover COMPL - rear backrest LH.
- LH side







- RH side







12. Referring to the above steps, disassemble the backrest assembly RH.
13. Detach the plastic fastener and hog ring, and then remove the headrest cover.







14. Remove the hog rings (A) on the back side of the rear seat cushion assembly.







15. Remove the hog rings (A), then remove the cover - rear cushion.







ASSEMBLY

CAUTION:
- Do not reuse hog rings.
- Secure the hog ring using hog ring pliers.
- Install the hog rings to the specified points securely and make sure that there is no wrinkle or twisting on the cover COMPL - rear backrest.

1. Assemble the cover COMPL - rear backrest and the cover - rear cushion in the same manner as for the front seat.
2. Make sure that all hog rings (A) are attached securely.







3. Assemble each part in the reverse order of disassembly.

NOTE:
- Do not contaminate or damage the cover COMPL - rear backrest and the cover - rear cushion.
- While installing the hog rings, prevent the cover COMPL - rear backrest and the cover - rear cushion from getting wrinkled.

Tightening torque:
Refer to "COMPONENT" of "General Description". [Ref. to REAR SEAT, COMPONENT, General Description.]

4. Before installation, check the following items.
- No tear and fray on the cover COMPL - rear backrest and the cover - rear cushion.
- No fray or deformation on each wire cable.

5. Install each part in the reverse order of removal.