Rear Seat

Rear Seat







REMOVAL

1. Remove the rear seat cushion assembly.
1. Push the corners of the rear seat cushion from above.
2. While pushing the corners of the rear seat cushion from above, pull the knob of the hook - seat cushion rear towards yourself.
3. While pulling the knob towards yourself, disconnect the hooks by lifting up the rear seat cushion.

NOTE: Pull the left side of the knob to disconnect the LH side hook, and pull the right side of the knob to disconnect the RH side hook.







4. Remove the hook (A) by pushing it back while lifting the front side of the rear seat cushion, and remove the rear seat cushion.







2. Remove the backrest assembly LH.
1. Remove the pillow assembly - rear backrest and tilt the backrest assembly LH forward.
2. Remove the clips located at the bottom of the cover COMPL - rear backrest LH and RH of the rear seat back.







3. Turn over the cover COMPL - rear backrest LH to remove the bolts.







4. Remove the backrest assembly LH from the hinge assembly.







NOTE: The backrest assembly cannot be removed unless pin positions on the hinge assembly side and backrest assembly side are aligned.

3. Remove the backrest assembly RH.
1. Remove the bolts and nuts.







2. Remove the backrest assembly RH from the hinge assembly.







NOTE: The backrest assembly cannot be removed unless pin positions on the hinge assembly side and backrest assembly side are aligned.

INSTALLATION

Install each part in the reverse order of removal.

NOTE:
- After installing the backrest assembly, make sure that each seat belt operates normally.
- Make sure that they are properly secured on each hook on the vehicle side.

Tightening torque:
Refer to "COMPONENT" of "General Description". [Ref. to REAR SEAT, COMPONENT, General Description.]