Removal and Replacement

Combination Meter

REMOVAL

1. Disconnect the ground cable from battery.
2. Release the lock, tilt the steering column to the lowest end and fully extend the column by the telescopic system.






3. Release the screws, clips and claws, and remove the visor - combination meter.






4. Remove the combination meter assembly.

CAUTION:
- Be careful not to damage the meter or instrument panel.
- Pay particular attention to avoid damaging the meter glass.

1. Remove the screws.






2. Pull the combination meter assembly toward you and disconnect the connector.






INSTALLATION

CAUTION:
- Make sure the electrical connector is connected securely.
- Make sure that each meter operates normally.
- When the combination meter assembly has been replaced, be sure to perform the registration of immobilizer.


Install each part in the reverse order of removal.