Overhaul

Headlight Assembly

DISASSEMBLY

HID HEADLIGHT BALLAST

WARNING: Because the headlight system uses high voltage, be careful not to perform work with wet hands. There is a possibility of electrical shock.

CAUTION:
- The HID type uses very high voltages for the lighting circuit. Make sure that the power supply is turned OFF before working.
- Do not leave the light assembly - head without the ballast - headlight for a long time. Dust, moisture, etc. entering the light assembly - head may affect its performance.

1. Disconnect the ground cable from battery.
2. Remove the light assembly - head.
3. Remove the cover - headlight.






4. Disconnect the bulb socket.






5. Remove the ballast - headlight.
1. Disconnect the connector.
2. Remove the screws and remove the ballast - headlight.






3. Guiding the bulb socket through the gap between housing and reflector, pull out the ballast - headlight.






ASSEMBLY

HID HEADLIGHT BALLAST

CAUTION:
- When installing the ballast - headlight, be sure to install the gasket.
- After installing the ballast to the vehicle, be sure to perform beam adjustment.


Assemble each part in the reverse order of disassembly.

Tightening torque: Light assembly - head: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)