Removal and Replacement

Headlight Assembly

REMOVAL

1. WHEN REMOVING RH SIDE

WARNING: Because the headlight system uses high voltage, be careful not to perform work with wet hands. There is a possibility of electrical shock.

CAUTION: The HID type uses very high voltages for the lighting circuit. Make sure that the power supply is turned OFF before working.

1. Disconnect the ground cable from battery.
2. Remove the clips and remove the air intake duct.






3. Remove the clip, and remove the bracket - grille.

CAUTION: To prevent damage to the bracket - grille, make sure to remove all clips.






4. Detach the flange section on the right side of the bumper face - front.
1. Apply protective tape (A) to the light assembly - head.
2. Release the clips, and while pushing up the lower side (a) of the bumper face - front, remove from (b) to (e).

CAUTION: Do not pull forcibly. It may damage the flange sections of the bumper face - front.






5. Remove the light assembly - head.

CAUTION: Be careful not to damage the light assembly - head, fender COMPL - front, and bumper face - front.

1. Disconnect connectors.
2. Remove the bolts and clips, and remove the light assembly - head.






2. WHEN REMOVING LH SIDE

WARNING: Because the headlight system uses high voltage, be careful not to perform work with wet hands. There is a possibility of electrical shock.

CAUTION: The HID type uses very high voltages for the lighting circuit. Make sure that the power supply is turned OFF before working.

1. Disconnect the ground cable from battery.
2. Detach the flange section on the bumper face - front left side.
1. Apply protective tape (A) to the light assembly - head.
2. Release the clips, and while pushing up the lower side (a) of the bumper face - front, remove in the order from (b) to (e).

CAUTION: Do not pull forcibly. It may damage the flange sections of the bumper face - front.






3. Remove the light assembly - head.

CAUTION: Be careful not to damage the light assembly - head, fender COMPL - front, and bumper face - front.

1. Disconnect the connector.
2. Remove the bolts and clips, and remove the light assembly - head.






3. WHEN REMOVING BOTH SIDE

WARNING: Because the headlight system uses high voltage, be careful not to perform work with wet hands. There is a possibility of electrical shock.

CAUTION: The HID type uses very high voltages for the lighting circuit. Make sure that the power supply is turned OFF before working.

1. Disconnect the ground cable from battery.
2. Remove the clips and remove the air intake duct.






3. Remove the bumper face - front.
4. Remove the light assembly - head.
1. Disconnect the connector.
2. Remove the bolts and clips, and remove the light assembly - head.






INSTALLATION

1. Install each part in the reverse order of removal.
2. Secure the flange section of the bumper face - front to the bracket - front bumper side.

CAUTION: Install the bumper face - front so that the front end of the under cover (b) comes inside the bumper face - front (a).






Tightening torque: Light assembly - head: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)

3. Adjust the headlight beam and fog light beam.
- Adjust the headlight beam.
- Adjust the fog light beam. (Model with fog light)