Horn: Service and Repair

Horn

REMOVAL

CAUTION: Do not remove the bumper face - front when removing the horn, in order to prevent damaging the claws of the bracket - front bumper corner and the bracket - front bumper side.

1. Disconnect the ground cable from battery.
2. Remove the clip, and remove the bracket - grille.






3. Remove the horn assembly - Lo.
1. Disconnect the connector.
2. Remove the horn bracket mounting bolt, and remove the horn assembly - Lo.






4. Remove the horn assembly - Hi.
1. Remove the bolts and clips, and remove the under cover - front.






2. Remove the clips, turn over the mud guard - front, and disconnect the horn connector.
3. Remove the horn bracket mounting bolt, and remove the horn assembly - Hi.

CAUTION: The resistor may become hot. Be careful not to burn yourself.






INSTALLATION

Install each part in the reverse order of removal.

CAUTION: Install the under cover so that the under cover front end (b) comes inside of the bumper face - front (a).






Tightening torque:
Horn assembly - Hi: 13 N.m (1.33 kgf-m, 9.6 ft-lb)
Horn assembly - Lo: 18 N.m (1.84 kgf-m, 13.3 ft-lb)