Rear Combination Light Assembly
Rear Combination Light AssemblyREMOVAL
1. 4 DOOR MODEL
1. Disconnect the ground cable from battery.
2. Remove the mat - trunk.
3. Remove the trim panel - trunk rear.
1. Remove the clip.
2. Release the claws, and remove the trim panel - trunk rear.
4. Remove the clips, and turn over the trim panel - trunk side.
5. Remove the light assembly - rear combination.
1. Remove the harness clip and connector.
2. Release the nuts and clips, then remove the light assembly - rear combination.
CAUTION: Be careful not to damage the clips.
2. 5 DOOR MODEL
1. Disconnect the ground cable from battery.
2. Remove the light assembly - rear combination.
CAUTION: Be careful not to damage the clips.
1. Release the bolts and clips, then pull out the light assembly - rear combination to the vehicle rear.
2. Disconnect the connector and remove the light assembly - rear combination.
INSTALLATION
CAUTION: For 4 door model, replace the gasket - rear combination (b) of the light assembly - rear combination (a) with a new part. If the gasket - rear combination is reused, water may come inside of the vehicle.
Install each part in the reverse order of removal.
Tightening torque: Light assembly - rear combination: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)