Electronic Throttle Actuator Relay: Service and Repair

Electronic Throttle Control Relay

REMOVAL

1. Disconnect the ground cable from battery.






2. Remove the knee airbag module.
3. Release the lock and remove the fuse holder from the relay & fuse box.






4. Disconnect the connectors from the relay & fuse box.
5. Remove the bolts (A) and nuts (B), and remove the relay & fuse box.






6. Remove the electronic throttle control relay from the relay block on the back side of the fuse block.






INSTALLATION
Install in the reverse order of removal.

Tightening torque: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)