Crankshaft Position Sensor

Crankshaft Position Sensor

REMOVAL
1. Disconnect the ground cable from battery.






2. Remove the clip (A) from the air intake boot.
3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).
4. Loosen the clamp (C) which connects the air intake boot and throttle body.






5. Remove the air intake boot from the throttle body, and move the air intake boot to the left side wheel apron.






6. Disconnect the connector (A) from the crankshaft position sensor, and remove the crankshaft position sensor from the cylinder block.






INSTALLATION
Install in the reverse order of removal.

Tightening torque: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)