Scan Tool Testing and Procedures

Subaru Select Monitor

OPERATION

1) Prepare the Subaru Select Monitor kit.





2) Prepare PC with Subaru Select Monitor installed.
3) Connect the USB cable to SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).

NOTE:
The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.

4) Connect the diagnosis cable to SDI.
5) Connect SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).





CAUTION:
Do not connect scan tools other than the Subaru Select Monitor.

6) Start the PC.
7) Turn the ignition switch to ON.
8) Run the "PC application for Subaru Select Monitor".

Read Current Data

OPERATION

For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
^ The support data list is as follows.