Cabin Temperature Sensor / Switch: Service and Repair

In-Vehicle Sensor (Auto A/C Model)

REMOVAL

CAUTION: Be careful not to damage the sensors and interior trims when removing.

1. Remove the knee airbag module.
2. Remove the in-vehicle sensor.
1. Disconnect the connector, and remove the aspirator hose.






2. Release the claws and remove the cover switch - starter.
3. Remove the screw and remove the in-vehicle sensor from the cover switch - starter.






INSTALLATION

Install each part in the reverse order of removal.

NOTE: Refer to "INSTALLATION" of "Knee Airbag Module".

Tightening torque:
Blower motor unit:
T: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)

Engine control module (ECM): 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)