Installation

INSTALLATION

1) Install the grommet to the toe board.





2) Insert the end of the column assembly - steering into the toe board grommet.
3) Tighten the column assembly - steering installation bolt located under the beam COMPL - steering with the tilt lever fixed.

Tightening torque:
20 Nm (2.04 kgf-m, 14.8 ft-lb)

4) Connect all connectors located under the beam COMPL - steering.
5) Connect the horn harness and airbag connector, and install the airbag module.
6) Install the knee airbag module.
7) Install the cover assembly - instrument panel LWR driver INN and OUT.
8) Install the universal joint assembly - steering.

CAUTION:
^ Always install the universal joint assembly - steering after installing the steering column to avoid damage to the universal joint assembly - steering.
^ Be sure to follow the tightening order and tightening torque of the universal joint assembly - steering to avoid the steering effort from becoming heavy.

9) Align the center position of the roll connector.
10) Install the steering wheel.