Removal

Steering Column

REMOVAL

1) Adjust the tilt position to the lowest position and lock the tilt lever.





2) Remove the driver's airbag module.

CAUTION:
Before performing service on the airbag module, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM".

(1) Using a hexagon wrench wrapped with protective tape, push in the snap pins to disengage the locks (3 places).





(2) Disconnect the horn harness and airbag connector, and remove the airbag module.





3) Remove the steering wheel.

CAUTION:
^ Always use the steering wheel puller for removal to avoid deforming the steering wheel.
^ If the steering wheel has been removed, make sure that the roll connector is not turned from the original position.

PREPARATION TOOL:
Steering wheel puller

(1) Disconnect the connector and remove the nut.
(2) Put alignment marks and remove the steering wheel.





4) Remove the cover assembly - instrument panel LWR driver.
(1) Remove the clips, and remove the cover - instrument panel side LH.





NOTE:
Using a plastic remover, open the cover - instrument panel side LH.

(2) Remove the screws and release the clips and claws.
(3) Disconnect the harness connectors, and remove the cover assembly - instrument panel LWR driver INN and the cover assembly - instrument panel LWR driver OUT.





5) Remove the nuts to remove the knee airbag module and disconnect the harness connector.





6) Remove the cover assembly - column.
(1) Remove the screws.
(2) Release the claw, and remove the cover assembly - column UPR and the cover assembly - column LWR.





7) Remove the switch assembly - combination.
(1) Disconnect the connector, and loosen the clamp to release the claws.
(2) Pull out the switch assembly - combination from the column assembly - steering.





8) Remove all connectors from the steering column.
9) Remove the universal joint assembly - steering.

CAUTION:
To prevent damage to the universal joint assembly - steering and error of handling force, make sure to remove the universal joint assembly - steering.

(1) Place alignment marks on the universal joint assembly - steering.

NOTE:
Place alignment marks on the following positions.
^ Between the column assembly - steering and the universal joint assembly - steering
^ Between the steering gearbox assembly and the universal joint assembly - steering

(2) Remove the bolt, and remove the universal joint assembly - steering.





10) Remove the two nuts under the beam COMPL - steering securing the steering column.





11) Pull out the column assembly - steering from the hole on toe board.

CAUTION:
Do not loosen the tilt lever when the steering column is not secured to the vehicle.

12) Remove the ignition key lock from the column assembly - steering.