Installation

INSTALLATION

CAUTION:
^ Be sure to use a new flange nut and self-locking nut.
^ Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.
^ Install the clamp - stabilizer bushing with the "G" character facing upward.
^ When installing, align the edge of identification paint (a) to the end face of the bushing (b).





1) Before installation, inspect the following items and replace any faulty part with a new one.
^ Check the bushing - stabilizer for abnormal cracks, fatigue or damage.
^ Check the stabilizer link assembly for damage.
2) Install each part in the reverse order of removal.

Tightening torque:
Clamp - stabilizer bushing: 30 Nm (3.06 kgf-m, 22.1 ft-lb)
Stabilizer link assembly: 38 Nm (3.87 kgf-m, 28.0 ft-lb)

3) Install the rear wheels.

Tightening torque:
120 Nm (12.24 kgf-m, 88.5 ft-lb)