Installation
INSTALLATION1) Install the joint to the transmission and secure with a spring pin.
2) Insert the gear shift lever from the room side.
NOTE:
Insert the rod and the stay, and then temporarily set them onto the transmission mount.
3) Lift up the vehicle.
4) Mount the cushion rubber on the vehicle body.
Tightening torque:
18 Nm (1.8 kgf-m, 13.3 ft-lb)
5) Connect the rod to the joint.
NOTE:
Use a new self-locking nut.
Tightening torque:
12 Nm (1.2 kgf-m, 8.9 ft-lb)
6) Connect the stay to the shift bracket.
NOTE:
Use a new self-locking nut.
Tightening torque:
18 Nm (1.8 kgf-m, 13.3 ft-lb)
7) Install the center exhaust cover.
Tightening torque:
18 Nm (1.8 kgf-m, 13.3 ft-lb)
8) Install the rear exhaust pipe.
9) Lower the vehicle.
10) Install the plate COMPL to the body.
Tightening torque:
18 Nm (1.8 kgf-m, 13.3 ft-lb)
(1) Set the plate COMPL to the vehicle.
(2) Temporarily tighten the bolt (A).
(3) Tighten the bolt (B).
(4) Tighten the bolt (A).
(5) Tighten the bolts (C) and (D).
(6) Tighten the console side cover attachment screws.
11) Install the harness clamp to the plate.
12) Install the boot and insulator assembly, and secure with a clamp.
13) Install the cover - shift lever, and install the gear shift knob.
14) Make sure the gears can be shifted accurately into each gear.