Power Window Switch: Service and Repair

Power Window Control Switch

REMOVAL

1. MAIN SWITCH

1. Remove the trim panel - front door.
2. Remove the panel - power window main switch.

CAUTION: Be careful not to damage the trim panel - front door with the panel - power window main switch.

1. Insert a sheet of protective paper (a) between panel - power window main switch and trim panel - front door.
2. Remove the screws and disconnect the connector.







3. Release the claws, and then remove the panel - power window main switch.







4. Release the claws, and then remove the switch - power window main.







2. SUB-SWITCH

Switch - power window sub front

For removal of the switch - power window sub front on the passenger's seat, refer to the removal procedure of the switch - power window main.

Switch - power window sub rear

1. Remove the trim panel - rear door.
2. Remove the panel - power window sub switch rear.

CAUTION: Be careful not to damage the trim panel - rear door with the panel - power window sub switch rear.

1. Insert a sheet of protective paper (a) between panel - power window sub switch rear and trim panel - rear door.
2. Remove the screws and disconnect the connector.







3. Release the claws, and then remove the panel - power window sub switch rear.







3. Release the claws, and then remove the switch - power window sub rear.







INSTALLATION

CAUTION:
- After installing the switch - power window main, always perform the initial setting.
Failure to do so may cause the improper activation of auto-reverse operation for pinching hazard prevention.
- Use protective paper to avoid damage to the trim panel.


1. Install each part in the reverse order of removal.
2. Perform initial setting operation (reset operation A).