Rear Wiper Motor
Rear Wiper MotorREMOVAL
1. Disconnect the ground cable from battery.
2. Remove the trim panel - rear gate UPR.
1. Remove the claws on the trim edge.
2. Release the claws in the center of trim, and remove the trim panel - rear gate UPR.
3. Remove the trim panel - rear gate pillar side.
1. Release the claws.
2. Remove the claws on the bottom of trim, and remove the trim panel - rear gate pillar side.
4. Remove the trim panel - rear gate LWR.
1. Remove the clips on both ends.
2. Release the clips, and remove the trim panel - rear gate LWR.
5. Remove the arm assembly - rear wiper.
1. Remove the cover - rear wiper arm.
2. Remove the nut, and remove the arm assembly - rear wiper.
6. Remove the motor assembly - rear wiper.
1. Disconnect the harness connector of the motor assembly - rear wiper.
2. Remove the bolts, and remove the motor assembly - rear wiper.
INSTALLATION
1. Install each part in the reverse order of removal.
2. Check that the mark on the cap - pivot wiper faces up, as shown in the figure.
REAR WIPER
Tightening torque:
T1: 7 N.m(0.71 kgf-m, 5.2 ft-lb)
T2: 8 N.m(0.82 kgf-m, 5.9 ft-lb)