Rear Gate Latch and Actuator Assembly
Rear Gate Latch and Actuator AssemblyREMOVAL
1. Disconnect the ground cable from battery.
2. Remove the rear gate trim.
3. Remove the bolt.
4. Disconnect the harness connector, and remove the rear gate latch and actuator assembly.
INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
T1: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
T2: 25 N.m (2.55 kgf-m, 18.4 ft-lb)