Front Drive Shaft Installation
INSTALLATION1) Replace the differential side retainer oil seal with a new part.
NOTE:
After pulling out the drive shaft, be sure to replace with a new oil seal.
2) Insert the AC into hub splines.
3) Draw the drive shaft into specified position.
CAUTION:
Do not hammer drive shaft when installing it.
4) Tighten the axle nut temporarily.
5) Using the ST, install the front drive shaft to transmission.
ST 28399SA010 OIL SEAL PROTECTOR
6) Connect the front arm ball joint to the housing.
Tightening torque:
50 Nm (5.10 kgf-m, 36.9 ft-lb)
7) Install the stabilizer link.
CAUTION:
Be sure to use a new self-locking nut.
Tightening torque:
38 Nm (3.87 kgf-m, 28 ft-lb)
8) While pressing the brake pedal, tighten the new axle nuts to the specified torque.
CAUTION:
Do not apply weight to the front axle before tightening the axle nut. Doing so may damage the hub bearing.
Tightening torque:
220 Nm (22.43 kgf-m, 162.3 ft-lb)
9) After tightening axle nut, lock it securely.
10) Fill transmission gear oil.
11) Install the front wheels.
Tightening torque:
100 Nm (10.20 kgf-m, 73.8 ft-lb)
12) Connect the battery ground terminal.
13) Inspect the wheel alignment and adjust if necessary.